Mercedes W201 190E 16V EVO

Hi Viper,

welcome to our board.
Looks very good what you have done! I hope my engine will look something like that next year. Had a few problems too.
But nothing what is impossible to get working with some time and money.
Can you tell me what fuel injectors you use? I plan to switch to electronic injection when doing the revision of my engine.

Greetings,
Florian

Nagilum hat geschrieben:Hi and welcome Viper.

I dunno why but I'd take your car, if you don't want it anymore...

I also like the rims and your choice to remove the SEC-stuff.
It looks like a lot of work and a bit money.
Also the new painted engine looks nice.

What was your reason to take the DTA S40?

"The car has been on the dyno. 171.5rwhp and 210nm"
Hmm isn't that a bit low? Are your sure that the compression was right when you dynoed the car?
I think you should earn about 40 PS/nm more with an EFI.

Good luck with finding the problem, hope it's nothing expensive.

Regards
- Nagi

Thanks

It has been a lot of work, a lot more than expected. Money? Dont want to talk about it

There is 2 reasons I picked the DTA ECU, one is price, the other is help. You cant do this with out people that know EFi and how this works. Going in to this EFi-rebuild, I didnt know shit about it.

I dynoed 171.5rwhp and 210nm at the wheels. I dont know the engine hp. Cant dyno 210hp at the wheels with this setup

LUDE hat geschrieben:Very nice looking car!

Wellcome on board!
I must say.....i like your air in take!
Very good Idea. Open Luftfilter that can`t get warm air!
Nice!

Your wheels.....excellent choice!
Do you have more pics of your full rail??
Or any technical drawings???

I dont have any drawings, just made by measuring and eye

I do have some pics.

Bild

florianh hat geschrieben:Hi Viper,

welcome to our board.
Looks very good what you have done! I hope my engine will look something like that next year. Had a few problems too.
But nothing what is impossible to get working with some time and money.
Can you tell me what fuel injectors you use? I plan to switch to electronic injection when doing the revision of my engine.

Greetings,
Florian

Thanks Florian!
Hard work and a lot of hours and you enginebay will look like this

I dont remember the makers of the injectors. Have some pics of them.

Bild